No products in the cart.
Clover, Clover, Shamrock Card
Clover, Clover, Shamrock Card
- February 11, 2020
- by Rebecca Walton
It's amazing what you can do with 2 little stamps! Using an oval die as a guide, Rebecca creates a beautiful oval wreath card.
Stamps Used
Supplies Used
-
Rated 0 out of 5
Lawn Fawn Stamp Shammy
$8.75Stamp Shammy
-
Rated 0 out of 5
EK® Cutter Bee Scissors
$10.99Scissors
-
Rated 0 out of 5
Rock-a-Blocks Clear – 2 Pack
$14.95Curved Stamping Block
-
Rated 0 out of 5
EZMount Clear Acrylic Small Blocks Set – 5 Blocks
$6.95Acrylic Stamping Blocks
-
Rated 0 out of 5
Double-Sided 3D Foam Tape
$3.99Double-Sided 3D Foam Tape - 6.56 feet
-
Rated 0 out of 5
MONO Multi Liquid Glue
$4.69Liquid Mono Glue
-
Rated 0 out of 5
Versafine Clair Shady Lane Ink – Full Size
$6.50Pigment Ink
-
Rated 0 out of 5
Versafine Clair Verdant Ink – Full Size
$6.50Pigment Ink
-
Rated 0 out of 5
Versafine Clair Green Oasis Ink – Full Size
$6.50Pigment Ink
Additional Supplies
- Cardstock – White
- Cardstock – Green
- Ribbon – Green (Grosgrain 3/8″)
Instructions
Prepare your card base by cutting a piece of 8-1/2″ x 11″ white cardstock at 5-1/2″, then fold both pieces in half to get 2, A2 (5-1/2″ x 4-1/4″) card bases.
Cut a single piece of green cardstock to 5-1/2″ x 4-1/4″ and a piece of white cardstock to 3-3/4″ x 5″.
From a scrap piece of white cardstock die cut a square that’s 2-3/4″. On that square measure from the top 1/2″ and draw a horizontal line. Measure from the bottom 1/2″ and draw a horizontal line. Then draw a horizontal line that’s centered between the upper and lower lines. Measure from the right and left of both lines 1/2″ and make a small mark on all three lines. Then make a mark on all three lines that’s centered between the left and right measurements.
Stamp the clover on all marks except the last one, on it stamp the shamrock.
Erase the lines. Attach the foam tape to the back.
Attach the green cardstock to the card base. Wrap the ribbon around the white panel and tape to the back. Stamp the sentiment in green ink.
Remove release paper from foam tape and attach the clover stamped panel, then center on the green cardstock and glue down.

Rebecca Walton
Share This Post on:
Share on facebook
Facebook
Share on pinterest
Pinterest