Total Weight: 0.1406 lbs
Curved Stamping Block
Acrylic Stamping Blocks
Double-Sided 3D Foam Tape - 6.56 feet
Liquid Mono Glue
Prepare your card base by cutting a piece of 8-1/2″ x 11″ white cardstock at 5-1/2″, then fold both pieces in half to get 2, A2 (5-1/2″ x 4-1/4″) card bases.
Cut a single piece of green cardstock to 5-1/2″ x 4-1/4″ and a piece of white cardstock to 3-3/4″ x 5″.
From a scrap piece of white cardstock die cut a square that’s 2-3/4″. On that square measure from the top 1/2″ and draw a horizontal line. Measure from the bottom 1/2″ and draw a horizontal line. Then draw a horizontal line that’s centered between the upper and lower lines. Measure from the right and left of both lines 1/2″ and make a small mark on all three lines. Then make a mark on all three lines that’s centered between the left and right measurements.
Stamp the clover on all marks except the last one, on it stamp the shamrock.
Erase the lines. Attach the foam tape to the back.
Attach the green cardstock to the card base. Wrap the ribbon around the white panel and tape to the back. Stamp the sentiment in green ink.
Remove release paper from foam tape and attach the clover stamped panel, then center on the green cardstock and glue down.